You need three figures: the size of the slat, the density of the timber and the number of rows. Our teak slats are 21 mm thick and 50, 70 or 90 mm wide, with a 5 mm gap. Teak weighs around 670 kg per m³ at 12% moisture content.
A 70 mm slat therefore comes to 0.021 x 0.07 x 670, or just under 1 kg per linear metre. With the gap, each row takes up 75 mm of height. That gives a little over 13 rows per metre of height and roughly 13 kg per square metre, or about 2.7 lb per square foot.

Width matters less than you might expect. A wider slat is heavier on its own, but you need fewer rows of them.
| Slat | Teak per metre of slat | Teak per m², single sided | Teak per m², double sided | Ipe per m², single sided |
|---|---|---|---|---|
| 50 mm | 0.70 kg | 12.8 kg | 25.6 kg | 20.0 kg |
| 70 mm | 0.98 kg | 13.1 kg | 26.3 kg | 20.6 kg |
| 90 mm | 1.27 kg | 13.3 kg | 26.7 kg | 20.9 kg |
These are calculated figures for the slats alone. Teak varies from batch to batch, from about 630 to 750 kg per m³, and wet timber weighs more.
With 70 mm slats you need 24 rows of 10 metres, so 240 linear metres of slat. In teak that is around 235 kg (about 520 lb), and in Ipe around 370 kg. Go for a double sided fence and the totals rise to roughly 470 kg in teak and 740 kg in Ipe.
Then add the posts. A 60 x 60 mm Azobe (ekki) post weighs just under 4 kg per metre. Clips and any EPDM membrane count too, although they are a small part of the total.

You will mostly notice it during installation. The slats are easier to carry and hold in place, particularly on the top rows. Our guide on how to install teak fencing takes you through the job.
There is a trade off. Teak is lighter because it is less dense, which also makes it softer. With a Janka hardness of 4,740 N against 15,520 N for Ipe, it picks up dents and scratches more easily. If the fence runs along a spot used by bikes, footballs or wheelbarrows, factor that in when you compare teak vs Ipe.
The posts stay the same. Wind pushes on the face of the fence, and that area is identical in teak and Ipe. So teak goes on the same 60 x 60 mm Azobe posts.

Teak is medium weight. At around 670 kg per m³ it is more than a third lighter than Ipe, which is around 1,050 kg per m³.
At 1.8 m high and single sided, the slats on one linear metre of fence weigh about 24 kg. Double sided, it is about 47 kg.
Take a look at our teak slatted fencing in 50, 70 or 90 mm and price up your own fence.
Tags for this article: